How to Take Platters from a Hard Drive

Platters on a hard drive are the physical storage location on the drive itself. Everything else on the hard drive is mechanics and electronics specific to these platters. A hard drive can house a single platter or multiple disks. The platters are highly sensitive to dust, static and abrasions, so they are tightly sealed inside the hard drive case. If the integrity of the hard drive and/or its data is important, the case should only be opened out of necessity and by an experienced technician in a “clean” environment. Things You’ll Need
T6 Torx Driver
T8 Torx Driver
Antistatic Rubber Gloves Wristband
Clean Room or
Show Box More Instructions
1
Place the hard drive on a clean, flat surface with the circuit board at the bottom. If you’re trying to preserve data and protect the dish, this surface should be inside a clean room or box, and you should only turn it over while wearing rubber gloves and grounding yourself with an antistatic wrist strap.
two

Remove all screws from the top surface of the unit using a Torx T8 driver. You may have to remove or drill stickers manufacturer to access them all. The top cover should now lift up and out of the case, exposing the large, circular trays and internal mechanisms.
3

Unscrew and remove the small piece of plastic that is found in the armor protruding across the bottom of the dish. This plastic piece barely covers a small part of the dish, but it is enough to prevent easy removal of the dish. The part is normally held by a single screw, which requires a Torx T6 driver.
4

Remove the magnetic plate at the base of the armature. The board is pressed down with strong magnetic force, then carefully drop it out of the case. Avoid moving this magnet across the platter as it may damage the data.
5

Lift the small, rubber-coated stopper exposed by removing the magnetic plate. This stopper prevents the armature from moving entirely off the plate. After lifting the cork, swing the armor away from the dish. The dish is unobstructed around its perimeter.
6

Remove the screws from the center restraint ring, which holds the dish down, using a Torx T6 driver. The crossmembers and retaining screw are mounted on a ball bearing system, so unscrewing can be difficult. Placing gentle external pressure on the base of the Torx driver minimizes rotation to allow loosening the T6s. Lift the restriction ring up and off the dish.
7

Carefully lift the tray up and off the center post. If your unit has multiple dishes, they will be stacked with spacer rings between the two. If you are removing the patterns and installing them on a unit of the same functional model, note the order and orientation of the crossbars. Follow the instructions in reverse to re-install the platters into the functional unit.

Related articles
· My Memorex DVD Burner is not recognizing blank discs…
· Definition of Type I and II Card Slots
· How to share an external hard drive on a Mac Router
· How to Repair a Corel Corel WordPerfect 8 File
· How to Combine a Hard Drive That Has Two Volumes
· Does a Seagate 6531 Hard Drive Work in a …
· What is SSD memory
· Using two hard drives
· How to Create a FAT32 Partition on a USB Hard Drive…
· How do I use portable hard drives
Featured articles
· How to restore the Backup.Arc file
· How to Check the Speed ​​of a CPU Fan
· Logitech Gamepads That Work With Macs
· How to Jump Start a CPU
· Will be Initializing a Data Wipe Drive
· How to Add a Quiz on iWeb
· Testing DVD Hardware for Problems
· About Speakers for a Mac Mini
· How to Convert an HP All-in-One Printer to Wires
· How to Run Itouch Applications on Mac Computers

Leave a Comment

Your email address will not be published. Required fields are marked *